• 3D Printing

    Can you Wifi a 3D printer?

    I was wondering if it was possible to Wifi my 3D printer. At the moment I need to either use an SD card or plug it into the front of my printer with a USB cord. These are two mechanical…

  • 3D Printing

    Filament Friend

    I was after an easy way to check if my 3D printer was out of filament. You can get filament sensors that detect the filament is missing (run out) but if the filament has broken after the sensor you would…

  • Hacks

    LP-E17 Mains adapter

    In this project, I needed a mains adapter for my EOS-M3 camera. Filming videos chews up a lot of battery. Going out to do some shooting when I finally find the time and to find the battery is dead is…

  • WLED

    Getting started with ESP-01 and WLED

    I have used the ESP-01 and WLED in a lot of my projects but haven’t really had an explainer video of how to get up and running, here, hopefully is all you need to know. Here is what you need…

  • WLED

    DIY RGB Keyboard

    In this project, I make an RGB keyboard using a K-Mart “gaming” keyboard. This keyboard already has an acrylic lens to allow RGB lights to filter through the keys. There is not an LED per key just 26 in total.…

  • Megacharger

    Megacharger

    For my RGB trampoline project, I had the unique issue of having a dozen batteries to charge at once. This usually meant filling up the phone chargers in the house and playing merry-go-round after a few days of use. In…

  • RC Car

    PSX controlled RC car

    In this project, I try to control an RC car with a Playstation 3 controller. The PlayStation 3 controller uses Bluetooth to connect to the PS3. Here we use a ESP32 to spoof this connection and then use the controls…