ATTiny85 blank board
Out of stock
This is the board I use for the scare mirror and lightsaber. This board is not programmed but cant be programmed with the arduio IDE
Support for the IDE (OSX/Windows/Linux).
Power via USB or External Source or 7-16 v to 5 v (automatic selection).
The Onboard, 150 ma 5 v Regulator.
Built-in USB and serial was debugging).
6 I/O Pins (2 informs the for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB).
8 k Flash Memory (about 6 k after bootloader).
The I2C and SPI (vis USI).
PWM on 3 pins (more possible with Software PWM).
The ADC on 4 pins.
The Power LED and the Test/Status LEDs.